Reference Guide

secondary
interface
Enter the keyword secondary to configure the secondary interface
followed by one of the following interfaces and slot/port information:
Fast Ethernet
interface:
enter the keyword FastEthernet
followed by the slot/port information
1-Gigabit
Ethernet
interface:
enter the keywordGigabitEthernet
followed by the slot/port information
Port Channel
interface:
enter the keywordport-channel
followed by a number:
• C-Series and S-Series Range: 1-128
• E-Series Range: 1 to 255 for
TeraScale and 1 to 512 for ExaScale
SONET interface: enter the keyword sonet followed by the
slot/port information
10-Gigabit
Ethernet
interface:
enter the keyword
TenGigabitEthernet followed by the
slot/port information
40-Gigabit
Ethernet
interface:
enter the keyword fortyGigE followed by
the slot/port information
control-vlan vlan-
id
Enter the keyword control-vlan followed by the VLAN ID. Range:
1 to 4094.
Defaults none
Command Modes CONFIGURATION (conf-frrp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced.
Usage
Information
This command causes the Ring Manager to take ownership of these two ports after the
configuration is validated by the IFM. Ownership is relinquished for a port only when the
interface does not play a part in any control VLAN, that is, the interface does not belong to any
ring.
Related
Commands
show frrp – displays the Resilient Ring Protocol configuration information.
717