Reference Guide

remote-url Enter the following location keywords and information:
• For a file on an FTP server, enter ftp:// user:password@hostip/
filepath
• For a file on a TFTP server, enter tftp:// hostip/filepath
Defaults none
Command Modes CONFIGURATION
Command History
Version 7.5.1.0 Introduced on C-Series
E-Series Original command
Usage
Information
To display these changes in the show bootvar command output, save the running
configuration to the startup configuration (using the copy command).
Related
Commands
show bootvar – displays the variable settings for the E-Series boot parameters.
boot system (S4810 and Z9000)
Tell the system where to access the FTOS image used to boot the system.
Z-Series, S4810
Syntax
This command was deprecated in FTOS 8.3.12.0.
boot system {gateway ip address| stack-unit [{0-11 | 0-7]| all]
[default | primary {system {A: | B:} | tftp: | | secondary]}
To return to the default boot sequence, use the no boot system command.
Parameters
gateway Enter the IP address of the default next-hop gateway for the
management subnet.
stack-unit Enter the stack-unit number for the master switch.
ip-address Enter an IP address in dotted decimal format.
0-11, 0-7, all Enter the stack-unit number. The S4810 range is 0 to 11. The Z9000
range is 0 to 7.
default Enter the keyword default to use the primary FTOS image.
primary Enter the keyword primary to use the primary FTOS image.
secondary Enter the keyword secondary to use the primary FTOS image.
tftp: Enter the keyword TFTP: to retrieve the image from a TFTP server.
tftp://hostip/filepath.
70