Reference Guide

Usage
Information
This command enables a hardware watchdog mechanism that automatically reboots an FTOS
switch/ router with a single unresponsive unit. This is a last resort mechanism intended to
prevent a manual power cycle.
show hardware layer2
Display Layer 2 ACL or eg data for the selected stack member and stack member port-pipe.
S-Series, Z-Series
Syntax
show hardware layer2 {eg-acl | in-acl} stack-unit id port-set
0-3
Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to select
between ingress or egress ACL data.
stack- unit id Enter the keyword stack-unit to select a stack ID. The unit ID
range for the Z9000 is 0.
port-set 0-3 Enter the keywords port-set with a port-pipe number — 0 or 3.
The S25 models of the S-Series have only port-pipe 0.
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced on the S-Series.
Usage
Information
The unit numbers given are internal port numbers. For a cross reference of the internal and
user port numbers, refer to the Z9000 Debugging and Diagnostics chapter in the FTOS
Configuration Guide for the Z9000 System .
show hardware layer3
Display Layer 3 ACL or QoS data for the selected stack member and stack member port-pipe.
S-Series, Z-Series
Syntax
show hardware layer3 {acl | qos} stack-unit 0-7 port-set 0-1
Parameters
acl | qos Enter either the keyword acl or the keyword qos to select between
ACL or QoS data.
stack-unit 0-7 Enter the keywords stack-unit followed by a numeral from 0 to 7
to select a stack ID.
port-set 0-1 Enter the keyword port-set with a port-pipe number, 0 or 1.
NOTE: The S25 models of the S-Series have only port-pipe 0.
653