Reference Guide

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the uplink-state-group command then the group ID number. The prompt changes to include (conf-

uplink-state-group-

groupID

Determining Chassis Mode

Chassis mode in FTOS determines which hardware is being supported in an E-Series chassis.

Chassis mode is programmed into an electrically erasable programmable read-only memory (EEPROM) on the backplane

of the chassis and the change takes place only after the chassis is rebooted. Configuring the appropriate chassis mode

allows the system to use all the ports on the card and recognize all software features.