Reference Guide

7 - -
8 - -
DCBX Commands
The following DCBX commands are supported on the S4810 platform.
advertise dcbx-app-tlv
Configure DCBX to send iSCSI TLV advertisements.
S4810
Syntax
advertise dcbx-app-tlv iscsi
To disable DCBX iSCSI TLV advertisements, use the no advertise dcbx-app-tlv
iscsi command.
Defaults Enabled
Command Modes PROTOCOL LLDP
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
Usage
Information
You can configure iSCSI TLVs to send either globally or on a specified interface. The interface
configuration takes priority over global configuration.
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to DCBX peers.
S4810
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-tlv
{fcoe | iscsi} command.
Parameters
{fcoe | iscsi} Enter the application priority TLVs, where:
• fcoe: enables the advertisement of FCoE in application
priority TLVs.
• iscsi: enables the advertisement of iSCSI in application
priority TLVs.
Defaults Application priority TLVS are enabled to advertise FCoE and iSCSI.
634