Reference Guide

description
Enter a text description of the DCB policy (PFC input or ETS output).
S4810
Syntax
description text
To remove the text description, use the no description command.
Parameters
text Enter the description of the output policy. The maximum is 32
characters.
Defaults none
Command Modes
• DCB INPUT POLICY
• DCB OUTPUT POLICY
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
• dcb-input – creates a DCB PFC input policy.
• dcb-policy input – applies the output policy.
• dcb-output – creates a DCBETS output policy.
• dcb-policy output – applies the output policy.
ets mode on
Enable the ETS configuration so that scheduling and bandwidth allocation configured in an ETS output policy or received
in a DCBX TLV from a peer can take effect on an interface.
S4810
Syntax
ets mode on
To remove the ETS configuration, use the no ets mode on command.
Defaults ETS mode is on.
Command Modes DCB OUTPUT POLICY
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you disable ETS in an output policy applied to an interface using the no ets mode on
command, any previously configured QoS settings at the interface or global level take effect. If
QoS settings are configured at the interface or global level and in an output policy map (the
622