Reference Guide

dcb-output
Create a DCB output policy to associate an ETS configuration with priority traffic.
S4810
Syntax
dcb-output policy-name
To remove the ETS output policy globally, use the no dcb output policy-name
command.
Parameters
policy-name Enter the DCB output policy name. The maximum is 32 alphanumeric
characters.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Create a DCB output policy to associate a priority group with an ETS output policy with
scheduling and bandwidth configuration. You can apply a DCB output policy on multiple egress
ports. When you apply an ETS output policy on an interface, ETS-configured scheduling and
bandwidth allocation take precedence over any configured settings in QoS output policies.
The ETS configuration associated with 802.1 priority traffic in a DCB output policy is used in
DCBX negotiation with ETS peers.
Related
Commands
dcb-policy output – applies the output policy.
dcb-policy output
Apply the output policy with the ETS configuration to an egress interface.
S4810
Syntax
dcb-policy output policy-name
To delete the output policy, use the no dcb-policy output command.
Parameters
policy-name Enter the output policy name.
Defaults none
Command Modes INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
620