Reference Guide

clear ets counters
Clear all ETS TLV counters on an interface.
S4810
Syntax
clear ets counters port-type slot/port
Parameters
port-type Enter the keywords port-type followed by the slot/port
information.
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
dcb-enable
Enable data center bridging.
S4810
Syntax
dcb enable
To disable DCB, use the no dcb enable command.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
By default, iSCSI is enabled on the unit and flowcontrol is enabled on all of the interfaces or if
link-level flow control is enabled on one or more interfaces. To enable DCB, do one of the
following:
• Apply the dcb-input policy command with the no pfc-mode command on to
all the interfaces.
• Disable flow-control on all of the interfaces.
Related
Commands
dcb-policy input – applies the input policy with the PFC configuration to an ingress interface.
619