Reference Guide

Related
Commands
dcb-policy input – applies the input policy with the PFC configuration to an ingress interface.
PFC Commands
The following PFC commands are supported on the S4810 platform.
clear pfc counters
Clear the PFC TLV counters and PFC statistics on an interface or stack unit.
S4810
Syntax
clear pfc counters [port-type slot/port | stack-unit {unit
number | all } all stack-ports all}]]
Parameters
port-type Enter the keywords port-type followed by the slot/port
information.
stack-unit unit
number
Enter the keywords stack-unit followed by the stack-unit number
to be cleared.
all stack-ports all Enter the keywords all stack-ports all to clear the counters
on all interfaces.
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
dcb-input
Create a DCB input policy to apply pause or flow control for specified priorities using a configure delay time.
S4810
Syntax
dcb-input policy-name
To delete the DCB input policy, use the no dcb-input command.
Parameters
policy-name Maximum: 32 alphanumeric characters.
Defaults none
Command Modes CONFIGURATION
606