Reference Guide

LINE Mode

To configure the console or virtual terminal parameters, use LINE mode.

To enter LINE mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the line command. Include the keywords console or vty and their line number available on the switch.

The prompt changes to include (config-line-console) or (config-line-vty).

You can exit this mode by using the exit command.

MAC ACCESS LIST Mode

To enter MAC ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the mac

access-list standard

or mac access-list extended command.

To enter MAC ACCESS LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Use the mac access-list standard or mac access-list extended command. Include a name for

the ACL. The prompt changes to include (conf-std-macl) or (conf-ext-macl).

You can return to CONFIGURATION mode by using the exit command.

MONITOR SESSION Mode

To enable and configure a traffic monitoring session using port monitoring, use MONITOR SESSION mode. For more

information, refer to Port Monitoring.

To enter MONITOR SESSION mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the monitor session command then the session ID. The prompt changes to include (conf-mon-sess-

sessionID

MULTIPLE SPANNING TREE (MSTP) Mode

To enable and configure MSTP, use MULTIPLE SPANNING TREE mode. For more information, refer to Multiple Spanning

Tree Protocol (MSTP).

To enter MULTIPLE SPANNING TREE mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the protocol spanning-tree mstp command. The prompt changes to include (conf-mstp).

You can return to CONFIGURATION mode by using the exit command.

OPENFLOW INSTANCE Mode

To enable and configure OpenFlow instances, use OPENFLOW INSTANCE mode. For more information, refer to SDN

Commands.

To enter OPENFLOW INSTANCE mode: