Reference Guide

Version 7.4.1.0 Added the lag-hash-mpls microcode.
Version 6.5.1.0 Added the eg-default and ipv4-320k CAM profiles.
Version 6.3.1.0 Introduced on the E-Series.
Usage
Information
You must save the running configuration using the copy running-config startup-
config
command after changing the CAM profile from CONFIGURATION mode. CAM profile
changes take effect after the next chassis reboot.
NOTE: Do not use the ipv4-egacl-16 CAM profile for Layer 2 egress ACLs.
NOTE: Do not make any changes to the CAM profile after you change the profile to
ipv4-320K and save the configuration until after you reload the chassis; any changes
lead to unexpected behavior. After you reload the chassis, you may make changes to the
IPv4 Flow partition.
show cam-acl
Display the details of the CAM profiles on the chassis and all line cards.
C-Series, Z-SEries, S4810
Syntax
show cam-acl
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
The display reflects the settings implemented with the cam-acl command.
Example (Default)
FTOS#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 6
Ipv4Acl : 5
Ipv6Acl : 0
Ipv4Qos : 1
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
VmanDualQos: 0
Ipv4pbr : 0
-- Line card 4 --
Current Settings(in block sizes)
L2Acl : 6
Ipv4Acl : 5
Ipv6Acl : 0
586