Reference Guide

Defaults none
Command Modes EXEC Privilege
Command History
Version 9.1(0.0) Updated reload type parameters.
Version 8.3.11.4 Introduced on the Z9000.
Version 8.3.10.0 Introduced for the S4810.
Usage
Information
Check the currently configured AutoConfiguration mode (BMP or Normal reload) on a switch
running BMP 3.0 using the show reload-type command.
The show bootvar or show system brief commands can also be used to display the
current reload mode for BMP 3.0. The commands include the path of the FTOS image file
retrieved from a DHCP server.
Example
FTOS#show reload-type
Reload-Type : normal-reload [Next boot : normal-reload]
Related
Commands
reload type – Configure the reload mode as Normal or BMP.
stop bmp
Stop the switch from reloading in BMP mode to prevent an infinite loop.
Z-Series, S4810
Syntax
stop bmp
NOTE: Replaces the stop jumpstart command.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.1(0.0) Introduced on Z9000 and S4810. Replaces the stop jumpstart
command.
Usage
Information
Use the stop bmp command on a switch running BMP 3.0 if the switch enters a loop while
reloading in BMP mode. The loop occurs when the switch is continuously trying to contact a
DHCP server and a DHCP server is not found. The stop bmp command stops the switch from
connecting to the DHCP server. After you use the stop bmp command, the next default
reload type is a normal reload as indicated in the
show reload-type or show system
brief command.
578