Reference Guide

• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If you do not configure the route map, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Usage
Information
When you enter the redistribute ospf process-id command without any other
parameters, FTOS redistributes all OSPF internal routes, external type 1 routes, and external
type 2 routes.
router bgp
Enter ROUTER BGP mode to configure and enable BGP.
E-Series
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
process-id Enter the number of the OSPFv3 process. The range is 1 to 65535.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
show capture bgp-pdu neighbor
Display BGP packet capture information for an IPv6 address on the E-Series.
C-Series, E-Series
Syntax
show capture bgp-pdu neighbor ipv6-address
Parameters
ipv6-address Enter the IPv6 address (X:X:X:X::X) of a BGP neighbor.
533