Reference Guide

metric-type (OPTIONAL) The external link type associated with the default route
advertised into a routing domain. You must specify one of the
following:
• external
• internal (default)
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If you do not configure the route map, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
redistribute ospf
Redistribute OSPFv3 routes into BGP.
E-Series
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id
command.
Parameters
process-id Enter the number of the OSPFv3 process. The range is 1 to 65535.
match external {1
| 2}
(OPTIONAL) Enter the keywords match external to redistribute
OSPF external routes. You can specify 1 or 2 to redistribute those
routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute
OSPFv3 internal routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
532