Reference Guide

The show ip bgp community command without any parameters lists BGP routes with at
least one BGP community attribute and the output is the same as for the show ip bgp
command output.
show ip bgp community-list
View routes that are affected by a specific community list.
C-Series, E-Series TeraScale, S-Series
Syntax
show ip bgp ipv4 multicast community-list community-list-name
Parameters
community-list-
name
Enter the name of a configured IP community list (max 16 characters).
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip bgp [ipv4 unicast] dampened-paths
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp damp command shown in the Example below.
Field
Description
Network Displays the network ID to which the route is dampened.
466