Reference Guide

route-map map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of
an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
FTOS software resolves the network address configured by the network command with the
routes in the main routing table to ensure that the networks are reachable using non-BGP
routes and non-default routes.
Related
Commands
redistribute – redistributes routes into the BGP.
redistribute
Redistribute routes into BGP.
C-Series, E-Series TeraScale, S-Series
Syntax
redistribute [connected | static] [route-map map-name]
To disable redistribution, use the no redistribution [connected | static]
[route-map
map-name] command.
Parameters
connected Enter the keyword connected to redistribute routes from physically
connected interfaces.
static
Enter the keyword static to redistribute manually configured
routes.
These routes are treated as incomplete routes.
461