Reference Guide

warning-only (OPTIONAL) Enter the keyword warning-only to set the router to
send a log message when the maximum value is reached. If this
parameter is not set, the router stops peering when the maximum
number of prefixes is reached.
Defaults threshold = 75
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ip-address | peer-group-
name} next-hop-self command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
Defaults Disabled.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ip-address | peer-group-name}
remove-private-as
command.
Parameters
ip-address Enter the IP address of the neighbor to remove the private AS
numbers.
458