Reference Guide

Example
FTOS(conf-router_bgp)#show confi
!
router bgp 45
neighbor suzanne peer-group
neighbor suzanne no shutdown
neighbor sara peer-group
neighbor sara shutdown
neighbor 13.14.15.20 peer-group suzanne
neighbor 13.14.15.20 shutdown
neighbor 123.34.55.123 peer-group suzanne
neighbor 123.34.55.123 shutdown
FTOS(conf-router_bgp)#
Related
Commands
capture bgp-pdu max-buffer-size – specifies a size for the capture buffer.
show ip bgp
View the current BGP IPv4 routing table for the system.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip bgp [ipv4 unicast] [network [network-mask] [longer-
prefixes]]
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
network (OPTIONAL) Enter the network address (in dotted decimal format) of
the BGP network to view information only on that network.
network-mask (OPTIONAL) Enter the network mask (in slash prefix format) of the
BGP network address.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view all
routes with a common prefix.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Added the add-path option to the S4810. Output on the S4810
shows the ADDPATH parameters.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
When you enable the bgp non-deterministic-med command, the show ip bgp
command output for a BGP route does not list the INACTIVE reason.
The following describes the show ip bgp command shown in the Example below.
417