Reference Guide

route-map map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of
an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced the ability to substitute IGP cost for MED when a peer/
peer-group outbound route-map is set as internal.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
With FTOS version 8.3.1.0 and later, you can use the redistribute command to advertise
the IGP cost as the MED on redistributed routes. When you set the route-map with metric-type
internal and applied outbound to an EBGP peer/peer-group, the advertised routes
corresponding to those peer/peer-group have the IGP cost set as MED.
If you do not configure the default-metric command, in addition to the redistribute
command, or there is no route map to set the metric, the metric for redistributed static and
connected is “0”.
To redistribute the default route (0.0.0.0/0), configure the neighbor default-
originate
command.
Related
Commands
neighbor default-originate – injects the default route.
redistribute isis
Redistribute IS-IS routes into BGP.
E-Series
Syntax
redistribute isis [WORD][level-1| level-1-2 | level-2] [metric
metric-value] [route-map map-name]
412