Reference Guide

Related
Commands
show ip protocols – views information on all routing protocols enabled and active on the E-
Series.
bgp router-id
Assign a user-given ID to a BGP router.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
bgp router-id ip-address
To delete a user-assigned IP address, use the no bgp router-id command.
Parameters
ip-address Enter an IP address in dotted decimal format to reset only that BGP
neighbor.
Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback interfaces
are configured, the highest IP address of a physical interface on the router.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
Peering sessions are reset when you change the router ID of a BGP router.
bgp soft-reconfig-backup
Use this command only when route-refresh is not negotiated to avoid the peer from resending messages.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
bgp soft-reconfig-backup
To return to the default setting, use the no bgp soft-reconfig-backup command.
Defaults Off
Command Modes ROUTER BGP
Command History
Version 9.1(0.0) Added support for IPv6.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
374