Reference Guide

To undo your VRRP BFD configuration, use the no vrrp bfd {all-neighbors |
neighbor ip-address } [interval interval min_rx min_rx
multiplier value role {active | passive}] command.
Parameters
all-neighbors Establish BFD sessions with all BFD neighbors on an interface.
neighbor ip-
address
Enter the IP address of the BFD neighbor.
interval
milliseconds
(OPTIONAL) Enter the keyword interval to specify non-default
BFD session parameters beginning with the transmission interval. The
range is 50 to 1000. The default is 100.
min_rx
milliseconds
Enter the keyword min_rx to specify the minimum rate at which the
local system would like to receive control packets from the remote
system. The range is 50 to 1000. The default is
100.
multiplier Enter the keyword multiplier to specify the number of packets
that must be missed in order to declare a session down. The range is
3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• Active—The active system initiates the BFD session. Both
systems can be active for the same session.
• Passive—The passive system does not initiate a session. It
only responds to a request for session initialization from the
active system.
The default is Active.
Defaults See Parameters.
Command Modes INTERFACE
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced on the E-Series.
356