Reference Guide

Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.10.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
bfd interval
Specify non-default BFD session parameters beginning with the transmission interval.
C-Series, E-Series, Z-Series, S4810
Syntax
bfd interval interval min_rx min_rx multiplier value role
{active | passive}
Parameters
interval
milliseconds
Enter the keywords interval to specify non-default BFD session
parameters beginning with the transmission interval. The range is 50
to 1000. The default is
100.
min_rx
milliseconds
Enter the keywords min_rx to specify the minimum rate at which
the local system would like to receive control packets from the
remote system. The range is 50 to 1000. The default is 100.
multiplier value Enter the keywords multiplier to specify the number of packets
that must be missed in order to declare a session down. The range is
3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• Active—The active system initiates the BFD session. Both
systems can be active for the same session.
• Passive—The passive system does not initiate a session. It
only responds to a request for session initialization from the
active system.
The default is Active.
Defaults As above.
Command Modes INTERFACE
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.10.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
344