Reference Guide

Parameters
weight Enter a number as the weight to be used by the route meeting the
route map specification. The range is 0 to 65535. The default is router-
originated = 32768 and all other routes = 0.
When there are multiple routes to the same destination, routes with a
higher weight are preferred.
Defaults router-originated = 32768; all other routes = 0
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
If you do not use the set weight command, router-originated paths have a weight attribute
of 32768 and all other paths have a weight attribute of zero.
show config
Display the current route map configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Example
FTOS(config-route-map)#show config
!
329