Reference Guide

exit Exit from access-list configuration mode
no Negate a command or set its defaults
permit Specify packets to forward
remark Specify access-list entry remark
seq Sequence numbers
show Show Standard ACL configuration
permit
Configure a filter to forward packets from a specific source MAC address.
C-Series, E-Series, S-Series, Z-Series
Syntax
permit {any | mac-source-address [mac-source-address-mask]}
[count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence
number.
• Use the no permit {any | mac-source-address mac-source-
address-mask} command.
Parameters
any Enter the keyword any to forward all packets received with a MAC
address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must match. If no
mask is specified, a mask of 00:00:00:00:00:00 is applied (in other
words, the filter allows only MAC addresses that match).
count (OPTIONAL) Enter the keyword count to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to log the packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring
section in the Port Monitoring chapter of the FTOS Configuration
Guide .
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
Version 8.3.11.1 Introduced on the Z9000.
294