Reference Guide

Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The ACL hit counters in this command increment the counters for each matching rule, not just
the first matching rule.
Example
FTOS#show mac accounting access-list mac-ext interface po 1
Extended mac access-list mac-ext on GigabitEthernet 0/11
seq 5 permit host 00:00:00:00:00:11 host 00:00:00:00:00:19
count (393794576 packets)
seq 10 deny host 00:00:00:00:00:21 host 00:00:00:00:00:29
count (89076777 packets)
seq 15 deny host 00:00:00:00:00:31 host 00:00:00:00:00:39
count (0 packets)
seq 20 deny host 00:00:00:00:00:41 host 00:00:00:00:00:49
count (0 packets)
seq 25 permit any any count (0 packets)
Extended mac access-list mac-ext on GigabitEthernet 0/12
seq 5 permit host 00:00:00:00:00:11 host 00:00:00:00:00:19
count (57589834 packets)
seq 10 deny host 00:00:00:00:00:21 host 00:00:00:00:00:29
count (393143077 packets)
seq 15 deny host 00:00:00:00:00:31 host 00:00:00:00:00:39
count (0 packets)
seq 20 deny host 00:00:00:00:00:41 host 00:00:00:00:00:49
count (0 packets)
seq 25 permit any any count (0 packets)
FTOS#
Standard MAC ACL Commands
When you create an access control list without any rule and then apply it to an interface, the ACL behavior reflects
implicit permit. These commands configure standard MAC ACLs.
The C-Series and S-Series platforms (except the S4810 system) support Ingress MAC ACLs only.
The S4810 and Z9000 support both Ingress and Egress MAC ACLs.
NOTE: For more information, also refer to the Commands Common to all ACL Types and Common MAC Access List
Commands sections.
291