Reference Guide

destination Enter the IP address of the network or host to which the packets are
sent.
dscp Enter the keyword dscp to deny a packet based on the DSCP value.
The range is 0 to 63.
message-type (OPTIONAL) Enter an ICMP message type, either with the type (and
code, if necessary) numbers or with the name of the message type.
The range is 0 to 255 for ICMP type and 0 to 255 for ICMP code.
count (OPTIONAL) Enter the keyword count to count packets the filter
processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
log (OPTIONAL, E-Series only) Enter the keyword log to have the
information kept in an ACL log file.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for
the ACL entry. The range is 0 to 254 (where 0 is the highest priority
and 254 is the lowest; lower-order numbers have a higher priority). If
you do not use the keyword order, the ACLs have the lowest order
by default (255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring
section in the Port Monitoring chapter of the FTOS Configuration
Guide .
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
Defaults Not configured.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command History
Version 8.3.1.0 Added the keyword dscp.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Added support for noncontiguous mask and added the monitor
option.
Version 6.5.10 Expanded to include the optional QoS order priority for the ACL
entry.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more
information, refer to the Quality of Service chapter of the
FTOS Configuration Guide .
273