Reference Guide

• Use the no seq sequence-number command if you know the filter’s sequence
number.
• Use the no deny {source [mask] | any | host ip-address}
command.
Parameters
source Enter the IP address in dotted decimal format of the network from
which the packet was sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D.
The mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous (discontiguous).
any Enter the keyword any to specify that all routes are subject to the
filter.
host ip-address Enter the keyword host and then enter the IP address to specify a
host IP address only.
count (OPTIONAL) Enter the keyword count to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to enter ACL
matches in the log.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP
values.
order (OPTIONAL) Enter the keyword order to specify the QoS order of
priority for the ACL entry. The range is 0 to 254 (where 0 is the highest
priority and 254 is the lowest; lower order numbers have a higher
priority). The default is, if you do not use the keyword order, the
ACLs have the lowest order by default (255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the “Flow-based Monitoring”
section in the Port Monitoring chapter of the FTOS Configuration
Guide .
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
Defaults Not configured.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
244