Reference Guide

Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS(config-ext-nacl)#show conf
!
ip access-list extended patches
FTOS(config-ext-nacl)#
Common IP ACL Commands
The following commands are available within both IP ACL modes (Standard and Extended) and do not have mode-
specific options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reflects an
implicit permit.
C-Series and S-Series (non-S4810) platforms support Ingress IP ACLs only.
The S4810 and Z-Series support both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types section.
access-class
Apply a standard ACL to a terminal line.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
access-class access-list-name
To remove an ACL, use the no access-class access-list-name command.
Parameters
access-list-name Enter the name of a configured Standard ACL, up to 140 characters.
Defaults Not configured.
Command Modes LINE
239