Reference Guide

mep cross-check enable
Enable cross-checking.
S-Series, S4810
Syntax
mep cross-check enable {port | vlan-id}
Parameters
port Down service with no VLAN association.
vlan-id Enter the VLAN to apply the cross-check.
Defaults none
Command Modes ECFM DOMAIN
Command History
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the S-Series.
mep cross-check start-delay
Configure the amount of time the system waits for a remote MEP to come up before the cross-check operation is
started.
S-Series, S4810
Syntax
mep cross-check start-delay number
Parameters
start-delay
number
Enter a start-delay in seconds. The range is 3 to 100 seconds.
Defaults 3 ccms
Command Modes ETHERNET CFM
Command History
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the S-Series.
212