Reference Guide

all Enter the keyword all to enable debugging of all VRRP groups.
bfd Enter the keyword bfd to enable debugging of all VFFP BFD
interactions.
database Enter the keyword database to display changes related to group,
prefix, and interface entries in the VRRP table.
packets Enter the keyword packets to enable debugging of VRRP control
packets.
state Enter the keyword state to enable debugging of VRRP state
changes
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
Command History
Version 8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Support
was added for IPv6 VRRP groups in non-default VRF instances.
Version 8.3.10.0 Introduced on the S4810.
Version 8.3.2.0 Introduced on the E-Series TeraScale.
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the FTOS returns No Active VRRP
group.
C-Series, E-Series, S-Series, S4810
Syntax
show vrrp ipv6 [vrid] [interface] [brief]
Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP group to
view only that group. The range is 1 to 255.
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number. For the E-Series, the range
is 1 to 255 for TeraScale.
• For SONET interfaces, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword vlan followed by
the VLAN ID. The VLAN ID range is from 1 to 4094.
1650