Reference Guide

Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies to a single interface. When used in conjunction with the vrrp delay
reload CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload
is 600 and the vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all
interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface.
Related
Command
vrrp delay reload – sets the delay time for VRRP initialization after a system reboot.
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
Z-Series, S4810
Syntax
vrrp delay reload seconds
Parameters
seconds Enter the number of seconds for the delay. The range is 0 to 900 (0
indicates no delay).
Defaults 0
Command Modes INTERFACE
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies to all the VRRP configured interfaces on a system. When used in
conjunction with the vrrp delay minimum CLI, the later timer rules the VRRP enabling.
For example, if
vrrp delay reload is 600 and the vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all
interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface.
You must save the configuration and reload the system for the delay timers to take effect.
Related
Command
vrrp delay minimum – sets the delay time for VRRP initialization after a line card reboot.
1647