Reference Guide

• On the C-Series and S-Series: You may specify both bytes of
the 2-byte S-Tag TPID. The range is 0 to FFFF. The default is
9100.
Defaults 0x9100
Command Modes CONFIGURATION
Command History
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale. C-Series and S-Series accept
both bytes of the 2-byte S-Tag TPID.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
E-Series original
Command
Usage
Information
For specific interoperability limitations regarding the S-Tag TPID, refer to the FTOS
Configuration Guide .
On E-Series TeraScale, the two characters you enter in the CLI for number become the MSB,
as shown below:
Number Resulting TPID
1 0x0100
10 0x1000
More than two
characaters
Configuration rejected.
On E-Series ExaScale, C-Series, and S-Series, four characters you enter in the CLI for number
are interpreted, as shown below:
Number Resulting TPID
1 0x0001
10 0x0010
81 0x0081
8100 0x8100
Related
Commands
portmode hybrid – sets a port (physical ports only) to accept both tagged and untagged frames.
A port configured this way is identified as a hybrid port in report displays.
vlan-stack trunk – specifies a Layer 2 port or port channel as a trunk port to the Stackable
VLAN network.
1617