Reference Guide

show inventory (S-Series and Z-Series)
Display the S-Series or Z-Series switch type, components (including media), and FTOS version, including hardware
identification numbers and configured protocols.
S-Series, Z-Series
Syntax
show inventory [media slot]
Parameters
media slot (OPTIONAL) Enter the keyword media followed by the stack ID of the
stack member for which you want to display pluggable media
inventory.
NOTE: This parameter is available but not supported in FTOS
version 8.3.11.4. Because stacking is not supported, if you use this
parameter, the output displays “Media not present or accessible”
(refer to the Usage Information section).
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.4 Output expanded to include Piece Part ID (PPID) and eSR4 optics.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced this version of the command for S-Series. S-Series output
differs from E-Series.
Usage
Information
If there are no fiber ports in the unit, just the header under show inventory media displays. If
there are fiber ports but no optics inserted, the output displays Media not present or
accessible .
Example (S-
Series)
FTOS#show inventory
System Name : S50v
system Mode : 1.0
Software Version : 7.6.1.0a
Unit Type Serial Number Part Number Revision
--------------------------------------------------------------
0 *S50-01-GE-48T-V DL267050013 7590003600 B
0 S50-01-10GE-2C N/A N/A N/A
0 S50-PWR-AC N/A N/A N/A
0 S50-FAN N/A N/A N/A
* - Management Unit
Software Protocol Configured
--------------------------------------------------------------
Example (S-
Series)
S50V_7.7#show inventory media ?
<0-7> Slot number
| Pipe through a command
161