Reference Guide

Uplink State Group : 7 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 16 Status: Disabled, Up
Upstream Interfaces : Gi 0/41(Dwn) Po 8(Dwn)
Downstream Interfaces : Gi 0/40(Dwn)
Related
Commands
• show running-config uplink-state-group – displays the current configuration of one or
more uplink-state groups.
• uplink-state-group – create an uplink-state group and enables the tracking of upstream
links.
uplink-state-group
Create an uplink-state group and enable the tracking of upstream links on a switch/ router.
S-Series (S50 only), S4810
Syntax
uplink-state-group group-id
To delete an uplink-state group, enter the no uplink-state-group group-id
command.
Parameters
group-id Enter the ID number of an uplink-state group. The range is 1 to 16.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.4.2.3 Introduced on the S-Series S50.
Usage
Information
After you enter the command, enter Uplink-State-Group Configuration mode to assign
upstream and downstream interfaces to the group.
An uplink-state group is considered to be operationally up if at least one upstream interface in
the group is in the Link-Up state.
An uplink-state group is considered to be operationally down if no upstream interfaces in the
group are in the Link-Up state. No uplink-state tracking is performed when a group is disabled
or in an operationally down state.
To disable upstream-link tracking without deleting the uplink-state group, use the no enable
command in uplink-state-group configuration mode.
Example
FTOS(conf)#uplink-state-group 16
FTOS(conf)#
02:23:17: %RPM0-P:CP %IFMGR-5-ASTATE_UP: Changed uplink state
group Admin state to up: Group 16
1606