Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4810P

1601

Defaults none

Command Modes UPLINK-STATE-GROUP

Command History

Version 8.3.12.0 Introduced on the S4810.

Version 8.4.2.3 Introduced on the S-Series S50.

Example

FTOS(conf-uplink-state-group-16)# description test

FTOS(conf-uplink-state-group-16)#

Commands

uplink-state-group – creates an uplink-state group and enables the tracking of upstream links.

downstream

Assign a port or port-channel to the uplink-state group as a downstream interface.

S-Series (S50 only), S4810

Syntax

downstream interface

To delete an uplink-state group, enter the no downstream interface command.

Parameters

interface

Enter one of the following interface types:

• Fast Ethernet: fastethernet {slot/port | slot/

port-range}

• 1-Gigabit Ethernet: gigabitethernet {slot/port |

slot/port-range}

• 10-Gigabit Ethernet: tengigabitethernet {slot/

port |slot/port-range}

• Port channel: port-channel {1-512 | port-

channel-range}

Where port-range and port-channel-range specify a

range of ports separated by a dash (-) and/or individual ports/port

channels in any order; for example: gigabitethernet

1/1-2,5,9,11-12 port-channel 1-3,5

. A comma is

required to separate each port and port-range entry.