Reference Guide

Usage
Information
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are
renumbered, only that specific unit is reset and comes up with the new unit number.
Example
FTOS#stack-unit 5 renumber 6
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Related
Commands
• reload – reboots FTOS.
• reset stack-unit – resets the designated S-Series stack member.
• show system (S-Series) – displays the current status of all stack members or a specific
member.
stack-unit stack-group
Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the unit is
assigned to the correct group.
S4810
Syntax
stack-unit unit-id stack-group stack-group-id
To remove the current stack group configuration, use the no stack-unit unit-id
stack-group stack-id command.
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is 0 to 1615.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Reset command mode from EXEC to CONFIGURATION.
Version 8.3.10.2 Introduced on the S4810.
Usage
Information
The following message displays to confirm the command.
WARNING: Setting ports Fo 0/60 as stack group will make their interface configs obsolete
after a reload.[confirm yes/no]: If “y” is entered, all non-default configurations on any
member ports of the current stack group will be removed when the unit is rebooted.
1548