Reference Guide

stack-unit provision
Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the
management unit.
S-Series
Syntax
stack-unit 0-11 provision {S25N|S25P|S25V|S50N|S50V|S4810}
Parameters
0-11 Enter a stack member identifier, from 0 to 11, of the switch that you
want to add to the stack.
S25N|S25P|S25V|
S50N|S50V|S4810
Enter the S-Series model identifier of the switch to be added as a
stack member. This identifier is also referred to as the provision type .
Defaults When this value is not set, a switch joining the stack is given the next available sequential
stack member identifier.
Command Modes CONFIGURATION
Command History
Version 7.7.1.0 Introduced on the S-Series.
Related
Commands
• reload – reboots FTOS.
• show system (S-Series) – displays the status of all stack members or a specific
member.
stack-unit renumber
Change the stack member ID of any stack member or a stand-alone S-Series.
S-Series
Syntax
stack-unit 0-11 renumber 0-11
Parameters
0-11 The first instance of this value is the stack member unit identifier,
from 0 to 11, of the switch that you want add to the stack. The range
is: 0 to 11. The second instance of this value is the desired new unit
identifier number.
Defaults none
Command Modes EXEC Privilege
Command History
Version 7.7.1.0 Introduced on the S-Series.
1547