Reference Guide

Stacking

All commands in this chapter are specific to the Dell Force10 operating software (FTOS) on the S-Series and S4810

platforms.

The commands are always available and operational, whether or not the S-Series has a stacking module inserted. You

can use the commands to pre-configure a switch, so that the configuration settings are invoked when the switch is

attached to other S-Series units.

For information about using the S-Series stacking feature, refer to the “Stacking S-Series Switches” chapter in the

FTOS

Configuration Guide

CAUTION: You cannot enable S4810 stacking simultaneously with virtual link trunking (VLT). If you enable both at

the same time, unexpected behavior occurs.

redundancy disable-auto-reboot

Prevent the S-Series stack management unit, stack member unit, and standby unit from rebooting if they fail.

S-Series

Syntax

redundancy disable-auto-reboot [members | 0-11]

To return to the default, use the no redundancy disable-auto-reboot stack-

unit command.

Defaults Disabled (the failed switch is automatically rebooted).

Command Modes CONFIGURATION

Command History

Version 8.3.1.0 Added the members option.

Version 7.7.1.0 Introduced on the S-Series.

Usage

Information

The range is 0 to 11. Enabling this command keeps the failed switch in the Failed state. The

switch does not reboot until it is manually rebooted. When enabled, it is not displayed in the

running-config. When disabled, it is displayed in the running-config.

Commands

show redundancy – displays the current redundancy status.

1541