Reference Guide

Related
Commands
logging on – enables logging.
logging trap
Specify which messages are logged to the Syslog server based the message severity.
C-Series, E-Series, S-Series, Z-Series
Syntax
logging trap [level]
To return to the default values, use the default logging trap command.
To disable logging, use the no logging trap command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following parameters:
emergencies, alerts, critical, errors, warnings,
notifications, informational, or debugging. The default
is 6 or informational.
Defaults 6 or informational
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series, S55.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
To block a type of message parameter, set the logging trap level to a lower number. For
example, to block severity messages at level 6, set the level to 5.
Related
Commands
logging – enables the logging to another device.
logging on – enables logging.
show logging
Display the logging settings and system messages logged to the internal buffer of the switch.
C-Series, E-Series, S-Series, Z-Series
Syntax
show logging [number | history [reverse][number] | reverse
[number] | summary]
Parameters
number (OPTIONAL) Enter the number of message to be displayed on the
output. The range is 1 to 65535.
1531