Reference Guide

FTOS(conf)#snmp-server community guest ro snmp-ro-acl
FTOS(conf)#
Related
Commands
ip access-list standard – names (or selects) a standard access list to filter based on IP
address.
ipv6 access-list – configures an access list based on IPv6 addresses or protocols.
show running-config snmp – displays the current SNMP configuration and defaults.
snmp-server contact
Configure contact information for troubleshooting this SNMP node.
C-Series, E-Series, S-Series, Z-Series
Syntax
snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server contact
command.
Parameters
text Enter an alphanumeric text string, up to 55 characters long.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server enable traps
Enable SNMP traps.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
snmp-server enable traps [notification-type] [notification-
option]
To disable traps, use the no snmp-server enable traps [notification-
type
] [notification-option] command.
Parameters
notification-type Enter the type of notification from the list below:
• bgp—Notification of changes in the BGP process.
1507