Reference Guide

Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use
the no disable command from RSTP mode.
Example
FTOS(conf)#protocol spanning-tree rstp
FTOS(config-rstp)##no disable
Related
Commands
disable – disables RSTP globally on the system.
show config
View the current configuration for the mode. Only non-default values are displayed.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Example
FTOS(conf-rstp)#show config
!
protocol spanning-tree rstp
no disable
bridge-priority 16384
show spanning-tree rstp
Display the RSTP configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show spanning-tree rstp [brief] [guard]
1415