Reference Guide

pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS(conf-router_rip)#show config
!
router rip
network 172.31.0.0
passive-interface GigabitEthernet 0/1
FTOS(conf-router_rip)#
show ip rip database
Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address (OPTIONAL) Specify an IP address in dotted decimal format to view
RIP information on that network only. If you enter an IP address, you
must also enter a mask for that IP address.
mask (OPTIONAL) Specify a mask, in /network format, for the IP address.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show ip rip database command shown in the Example
below.
Field Description
Total number of
routes in RIP
database
Displays the number of RIP routes stored in the RIP database.
100.10.10.0/24
directly connected
Lists the route(s) directly connected.
1390