Manualshelf

Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4810P
1381138213831384138513861387138813891390
router rip
Enter ROUTER RIP mode to configure and enable RIP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
router rip
To disable RIP, use the no router rip command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
To enable RIP, you must assign a network address using the network command.
Example
FTOS(conf)#router rip
FTOS(conf-router_rip)#
Related
Commands
network – enables RIP.
exit – returns to CONFIGURATION mode.
show config
Display the changes you made to the RIP configuration. Default values are not shown.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes ROUTER RIP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
1389