Reference Guide

ip split-horizon
Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any
routes learned over a specific interface to be sent back out that interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip split-horizon
To disable split-horizon, use the no ip split-horizon command.
Defaults Enabled
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
ip poison-reverse – sets the prefix for RIP routing updates.
maximum-paths
Set RIP to forward packets over multiple paths.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths commands.
Parameters
number Enter the number of paths. The range is 1 to 16. The default is 4 paths.
Defaults 4
Command Modes ROUTER RIP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
1381