Reference Guide

To remove the threshold values, use the no threshold min number max number
command.
Parameters
min number Enter the keyword min followed by the minimum threshold number
for the WRED profile. The range is 1024 to 77824 KB.
max number Enter the keyword max followed by the maximum threshold number
for the WRED profile. The range is 1024 to 77824 KB.
Defaults none
Command Modes CONFIGURATION (config-wred)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
Use this command to configure the minimum and maximum threshold values for user-defined
profiles. Additionally, use this command to modify the minimum and maximum threshold values
for the pre-defined WRED profiles. If you delete the threshold values of the pre-defined WRED
profiles, the profiles revert to their original default values.
Pre-Defined WRED Profile Name Minimum Threshold Maximum Threshold
wred_drop 0 0
wred_ge_y 1024 2048
wred_ge_g 2048 4096
wred_teng_y 4096 8192
wred_teng_g 8192 16384
Related
Commands
wred-profile – creates a WRED profile.
trust
Specify dynamic classification (DSCP) or dot1p to trust.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
trust {diffserv [fallback]| dot1p [fallback]| ipv6-diffserv}
Parameters
diffserv Enter the keyword diffserv to specify trust of DSCP markings.
dot1p Enter the keyword dot1p to specify trust dot1p configuration.
fallback Enter the keyword fallback to classify packets according to their
DSCP value as a secondary option in case no match occurs against
the configured class maps.
1366