Reference Guide

port-set number Enter the keywords port-set followed by the line card’s port pipe.
The range is 0 or 1.
interface
interface
Enter the keyword interface followed by one of the keywords
below and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/ port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
summary (OPTIONAL) Enter the keyword summary to display only the total
number of CAM entries.
Defaults none
Command Modes EXEC
Command History
Version 6.5.1.0 Introduced on the E-Series.
Usage
Information
NOTE:
• The entry TRUST-DSCP in the Queue column indicates that the trust diffserv is
configured on the policy-map.
• A hyphen (-) entry in the DSCP Marking column indicates that there is no DSCP
marking.
• In the Proto column (Protocol), IP, ICMP, UDP, and TCP strings are displayed. For
other protocols, the corresponding protocol number is displayed.
Example
(Interface)
FTOS#sh cam layer3-qos interface gigabitethernet 2/1
Cam Port Dscp Proto Tcp Src Dst SrcIp DstIp DSCP Queue
Index Flag Port Port Marking
-----------------------------------------------------------
23488 1 0 0 0x0 0 0 0.0.0.0/0 0.0.0.0/0-TRUST-DSCP
FTOS#
Example
(Linecard)
FTOS#show cam layer3-qos linecard 13 port-set 0
Cam Port Dscp Proto Tcp Src Dst SrcIp DstIp DSCP
Queue
Index Flag Port Port Marking
---------------------------------------------------------------
24511 1 0 TCP 0x5 2 5 1.0.0.1/24 2.0.0.2/24-
TRUST-DSCP
24512 1 0 UDP 0x2 2 5 8.0.0.8/24 8.0.0.8/24 23 3
FTOS#
1352