Reference Guide

with SFP - 2-port
10GE with SFP+
E46VB 36-port GE 10/100/1000Base-T with RJ45 and PoE - 8-port
FE/GE with SFP -
2-port 10GE with SFP+
E48PB 48-port FE/GE line card with SFP optics (CB)
E48TB 48-port GE 10/100/1000Base-T line card with RJ45
interfaces (CB)
E48VB 48-port GE 10/100/1000Base-T line card with RJ45
interfaces and PoE (CB)
EX4PB 4-port 10GE LAN PHY line card with XFP optics (CB)
EX8PB 8-port 10GE LAN PHY line card with XFP optics (CB)
FTOS#linecard 3 EX4PB
FTOS#show linecard 3
-- Line card 11 --
Status : not present
Required Type : EX4PB - 4-port 10GE LAN PHY line card with XFP
optics (CB)
Related
Commands
show linecard – displays the line card(s) status.
linecard (4-port 40G line card)
Pre-configure an empty slot in an E-Series ExaScale switch for a 4-port 40 GigabitEthernet (40GE) line card or
reconfigure a slot in which you have hot-swapped a 4-port 40GE line card.
E-Series ExaScale Only
Syntax
linecard slot-number card-type {linerate | oversubscribed}
active-ports port-set0 port-number [port-number] port-set1
port-number [port-number]
Parameters
slot-number Enter the slot number in which you will use the line card. The range is
0 - 13 on the E1200i and 0 - 5 on the E600i.
card-type Enter the line card ID. Valid values are:
• EX04PH: Configures the slot for a 6-port 40GE line card with
10M CAM (LC-EH-40GE-4P).
• EX04PJ: Configures the slot for a 6-port 40GE line card with
40M CAM (LC-EJ-40GE-4P).
linerate Configure two ports on the line card to transmit data at full line rate
(40 Gbps).
oversubscribed Configure four ports on the line card for oversubscribed data
transmission.
active-ports Enable the active ports for the specified mode (linerate or
oversubscribed).
135