Reference Guide

service-policy output
Apply an output policy map to the selected interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
service-policy output policy-map-name
To remove the output policy map from the interface, use the no service-policy
output policy-map-name command.
Parameters
policy-map-name Enter the name for the policy map in character format (16 characters
maximum). You can identify an existing policy map or name one that
does not yet exist.
Defaults none
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
A single policy-map can be attached to one or more interfaces to specify the service-policy for
those interfaces. A policy map attached to an interface can be modified.
Related
Commands
policy-map-output – creates an output policy map.
service-queue
Assign a class map and QoS policy to different queues.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
service-queue queue-id [class-map class-map-name] [qos-policy
qos-policy-name]
To remove the queue assignment, use the no service-queue queue-id [class-
map class-map-name] [qos-policy qos-policy-name] command.
Parameters
queue-id Enter the value used to identify a queue. The range is 0 to 7 on the E-
Series (eight queues per interface), 0 to 3 on the C-Series and S-
Series (four queues per interface; four queues are reserved for
control traffic).
class-map class-
map-name
(OPTIONAL) Enter the keyword class-map followed by the class
map name assigned to the queue in character format (16 character
maximum).
1348