Reference Guide

Defaults none
Command Modes CONFIGURATION
Command History
Version 7.7.1.0 Introduced on the E-Series.
queue egress
Assign a WRED Curve to all eight egress Multicast queues or designate the percentage for the Multicast bandwidth
queue.
E-Series, S4810
Syntax
queue egress multicast linecard {slot number port-set number |
all} [wred-profile name | multicast-bandwidth percentage]
To return to the default, use the no queue egress multicast linecard {slot
number port-set number | all} [wred-profile name | multicast-
bandwidth percentage] command.
Parameters
linecard number Enter the keyword linecard followed by the line card slot number.
For the E-Series, the range is 0 to 13 on a E1200, 0 to 6 on a E600/E600i,
and 0 to 5 on a E300.
port-set number Enter the keywords port-set followed by the line card’s port pipe.
The range is 0 or 1.
all Enter the keyword all to apply to all line cards.
wred-profile
name
(OPTIONAL) Enter the keywords wred-profile followed by your
WRED profile name in character format (16 character maximum). Or
use one of the pre-defined WRED profile names.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
multicast-
bandwidth
percentage
(OPTIONAL) Enter the keywords multicast-bandwidth
followed by the bandwidth percentage. The range is 0 to 100%.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.8.10 Introduced on the S4810.
Version 7.5.1.0 Added support for multicast-bandwidth.
Version 7.4.1.0
and 6.5.3.0
Introduced on the E-Series.
Usage
Information
This command does not uniquely identify a queue, but rather identifies only a set of queues.
The WRED curve is applied to all eight egress Multicast queues.
Important Points to Remember — Multicast-Bandwidth Option
1342