Reference Guide

show interfaces rate
Display information of either rate limiting or rate policing on the interface.
E-Series
Syntax
show interfaces [interface] rate [limit | police]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
limit (OPTIONAL) Enter the keyword limit to view the outgoing traffic
rate.
police (OPTIONAL) Enter the keyword police to view the incoming traffic
rate.
Command Modes
• EXEC
• EXEC Privilege
Command History
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show interfaces rate limit command shown in the
Example below.
Field Description
Rate limit Committed rate (Mbps) and burst size (KB) of the committed rate.
peak Peak rate (Mbps) and burst size (KB) of the peak rate.
Traffic monitor 0 Traffic coming to class 0.
Normal Committed rate (Mbps) and burst size (KB) of the committed rate.
peak Peak rate (Mbps) and burst size (KB) of the peak rate.
Out of profile Yellow Number of packets that have exceeded the configured committed
rate.
Out of profile Red Number of packets that have exceeded the configured peak rate.
1325